22 November 2010
Update on rescue at Pike River mine
A robot and remote, real-time gas sampling equipment are being readied to assist rescue efforts at the Pike River coal
mine, where 29 men are unaccounted for following an explosion in the mine on Friday afternoon (19 November).
Pike River Chief Executive, Peter Whittall, says a New Zealand Army robot is on standby at the mine and if it can
operate safely within the main access tunnel, it would be used first to check the area where an underground loader is
thought to be blocking the access way. A longer control cable is being sought for the machine which might allow it to
proceed further along the 2.2km tunnel towards the area of coal workings.
The gas sampling tubing from Queensland would allow the second gas survey point now being drilled to be connected to
analysis equipment and speed up the turnaround of results.
Mr Whittall says the drilling which is being done to provide a second place to take gas readings is progressing well,
with the drill having cut more than 100 metres of its 162 metre target. A special drill bit would be used for the last
10 metres to minimise the chance of any sparking when it breaks through into the mine drive below.
Depending on where the drill hole intersects the drive, laser and other imaging gear which can be lowered down the hole
may provide more information about the situation deeper in the mine, he says.
Fibre-optic cable is being laid from the mine portal area to the top of the main ventilation shaft. It would allow the
rescue planners to see any changes in the air coming out of the shaft. The Department of Conservation is assisting with
track access to the new sample points.
Another group of relatives – two from each family with a missing man – would be escorted to the site shortly before
midday, he says. The Prime Minister, the Rt Hon John Key, was also to visit the site.
ENDS